Difference between revisions of "IGT:ToolKit/Build-OpenIGTLink"
From NAMIC Wiki
| Line 14: | Line 14: | ||
$ mkdir OpenIGTLink-build | $ mkdir OpenIGTLink-build | ||
| − | Configure using CMake 2.6 | + | Configure using CMake 2.6: Press the 'c' key, then set '''Slicer3_DIR''' to your build directory of Slicer3 (i.e. Slicer3-build), then press the 'g' key to generate the makefiles. |
$ cd OpenIGTLink-build | $ cd OpenIGTLink-build | ||
$ ccmake ../OpenIGTLink | $ ccmake ../OpenIGTLink | ||
Revision as of 02:26, 4 June 2008
Home < IGT:ToolKit < Build-OpenIGTLinkBack to IGT:ToolKit
Notes before you begin
- Slicer3 is assumed to have been built on your computer in the directory igt-tutorial
- CMake 2.6 is absolutely required. If you don't have it installed, you can use the version of ccmake found in igt-tutorial/Slicer3-lib/CMake-build/bin (it will be CMake 2.6)
Instructions
First, get the OpenIGTLink module source code from the repository:
$ cd igt-tutorial $ svn co http://www.na-mic.org/svn/NAMICSandBox/trunk/IGTLoadableModules/OpenIGTLink OpenIGTLink
Create a new build directory:
$ mkdir OpenIGTLink-build
Configure using CMake 2.6: Press the 'c' key, then set Slicer3_DIR to your build directory of Slicer3 (i.e. Slicer3-build), then press the 'g' key to generate the makefiles.
$ cd OpenIGTLink-build $ ccmake ../OpenIGTLink
If the previous command has completed without error, you can start building:
$ make
Upon completion, you should find libOpenIGTLink.so (Linux) or libOpenIGTLink.dylib (Mac OS X) at igt-tutorial/OpenIGTLink-build/lib/Slicer3/Modules
