Difference between revisions of "2008 IGT Project Week Prostate Breakout Session"
From NAMIC Wiki
(9 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
− | + | Back to [[2008 IGT Project Week]] | |
Moderator: | Moderator: | ||
Line 10: | Line 10: | ||
*Final walk through of the steps | *Final walk through of the steps | ||
− | * | + | ==Setup== |
+ | **Power supply | ||
+ | **Cable (Eithernet, power) | ||
+ | **Robot and the associated computers | ||
+ | **MRI | ||
+ | **Slicer and associated computers | ||
+ | **Radvision | ||
+ | **network (IP address?) | ||
+ | **compresso (connector needs to be checked ?) | ||
+ | **monitor (how many, where?) (needs one from Monitor) | ||
+ | **phantom | ||
+ | **Coil | ||
+ | |||
+ | ==Localiser== | ||
+ | *Image transfer (DICOM OK) | ||
+ | *Z-frame and calibration (Jack was able to get good registration. | ||
+ | |||
+ | *Open IGT Link image transfer (Tonight, may continue to tomorrow) | ||
+ | *transferring calibration result (open igt link CLEAR) | ||
+ | |||
+ | ==Planning== | ||
+ | *Planning in Slicer (based DICOM, clear, CLEAR) | ||
+ | *Planning in RadVision | ||
+ | |||
+ | ==Scan Control== | ||
+ | *Scan control from Slicer | ||
+ | *Scan control from Radvision (TUESAY and Wednesday) | ||
+ | |||
+ | ==Robot Control== | ||
+ | *robot control from Slicer (POSITION CLEAR, Work for TUESDAY) | ||
+ | *robot control from RadVision (POSITION CLEAR, for TUESDAY) | ||
+ | |||
+ | ==Device placement== | ||
+ | *Needle (JHU) | ||
+ | *Seeds (JHU) |
Latest revision as of 21:02, 8 December 2008
Home < 2008 IGT Project Week Prostate Breakout SessionBack to 2008 IGT Project Week
Moderator:
- Noby Hata
Attendees:
Agenda:
- Final walk through of the steps
Setup
- Power supply
- Cable (Eithernet, power)
- Robot and the associated computers
- MRI
- Slicer and associated computers
- Radvision
- network (IP address?)
- compresso (connector needs to be checked ?)
- monitor (how many, where?) (needs one from Monitor)
- phantom
- Coil
Localiser
- Image transfer (DICOM OK)
- Z-frame and calibration (Jack was able to get good registration.
- Open IGT Link image transfer (Tonight, may continue to tomorrow)
- transferring calibration result (open igt link CLEAR)
Planning
- Planning in Slicer (based DICOM, clear, CLEAR)
- Planning in RadVision
Scan Control
- Scan control from Slicer
- Scan control from Radvision (TUESAY and Wednesday)
Robot Control
- robot control from Slicer (POSITION CLEAR, Work for TUESDAY)
- robot control from RadVision (POSITION CLEAR, for TUESDAY)
Device placement
- Needle (JHU)
- Seeds (JHU)