Difference between revisions of "2008 IGT Project Week Prostate Breakout Session"
From NAMIC Wiki
| (8 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | + | Back to [[2008 IGT Project Week]] | |
Moderator: | Moderator: | ||
| Line 11: | Line 11: | ||
==Setup== | ==Setup== | ||
| − | **Robot | + | **Power supply |
| − | **MRI | + | **Cable (Eithernet, power) |
| − | **Slicer | + | **Robot and the associated computers |
| + | **MRI | ||
| + | **Slicer and associated computers | ||
**Radvision | **Radvision | ||
| − | **network | + | **network (IP address?) |
| − | ** | + | **compresso (connector needs to be checked ?) |
| − | **monitor | + | **monitor (how many, where?) (needs one from Monitor) |
| − | **phantom | + | **phantom |
**Coil | **Coil | ||
| + | ==Localiser== | ||
| + | *Image transfer (DICOM OK) | ||
| + | *Z-frame and calibration (Jack was able to get good registration. | ||
| − | + | *Open IGT Link image transfer (Tonight, may continue to tomorrow) | |
| − | * | + | *transferring calibration result (open igt link CLEAR) |
| − | *calibration result (open igt link) | ||
==Planning== | ==Planning== | ||
| − | *Planning in Slicer | + | *Planning in Slicer (based DICOM, clear, CLEAR) |
*Planning in RadVision | *Planning in RadVision | ||
==Scan Control== | ==Scan Control== | ||
*Scan control from Slicer | *Scan control from Slicer | ||
| − | *Scan control from Radvision | + | *Scan control from Radvision (TUESAY and Wednesday) |
==Robot Control== | ==Robot Control== | ||
| − | *robot control from Slicer | + | *robot control from Slicer (POSITION CLEAR, Work for TUESDAY) |
| − | *robot control from RadVision | + | *robot control from RadVision (POSITION CLEAR, for TUESDAY) |
==Device placement== | ==Device placement== | ||
| − | *Needle | + | *Needle (JHU) |
| − | *Seeds | + | *Seeds (JHU) |
Latest revision as of 21:02, 8 December 2008
Home < 2008 IGT Project Week Prostate Breakout SessionBack to 2008 IGT Project Week
Moderator:
- Noby Hata
Attendees:
Agenda:
- Final walk through of the steps
Setup
- Power supply
- Cable (Eithernet, power)
- Robot and the associated computers
- MRI
- Slicer and associated computers
- Radvision
- network (IP address?)
- compresso (connector needs to be checked ?)
- monitor (how many, where?) (needs one from Monitor)
- phantom
- Coil
Localiser
- Image transfer (DICOM OK)
- Z-frame and calibration (Jack was able to get good registration.
- Open IGT Link image transfer (Tonight, may continue to tomorrow)
- transferring calibration result (open igt link CLEAR)
Planning
- Planning in Slicer (based DICOM, clear, CLEAR)
- Planning in RadVision
Scan Control
- Scan control from Slicer
- Scan control from Radvision (TUESAY and Wednesday)
Robot Control
- robot control from Slicer (POSITION CLEAR, Work for TUESDAY)
- robot control from RadVision (POSITION CLEAR, for TUESDAY)
Device placement
- Needle (JHU)
- Seeds (JHU)
