Difference between revisions of "IGT:ToolKit/Build-OpenIGTLink"
| Line 11: | Line 11: | ||
You need to set '''Slicer3_DIR''' as the build directory of Slicer3, i.e. Slicer3-buld. Also, make sure you have version 2.6 of CMake installed. If you don't, you can find in Slicer3-lib/CMake-build/bin. After configuration, run | You need to set '''Slicer3_DIR''' as the build directory of Slicer3, i.e. Slicer3-buld. Also, make sure you have version 2.6 of CMake installed. If you don't, you can find in Slicer3-lib/CMake-build/bin. After configuration, run | ||
make | make | ||
| − | To build OpenIGTLink. Upon completion, you should find '''libOpenIGTLink.so''' here at igt-tutorial/OpenIGTLink-build/lib/Slicer3/Modules | + | To build OpenIGTLink. Upon completion, you should find '''libOpenIGTLink.so''' here at igt-tutorial/OpenIGTLink-build/lib/Slicer3/Modules. Copy it to igt-tutorial/Slicer3-3.0.2008-05-21-linux-x86/lib/Slicer3/Modules |
Revision as of 17:45, 23 May 2008
Home < IGT:ToolKit < Build-OpenIGTLinkBack to IGT:ToolKit
You are assumed that Slicer 3 has been built on your computer.
1. In directory igt-tutorial, download OpenIGTLink module source code:
svn co http://www.na-mic.org/svn/NAMICSandBox/trunk/IGTLoadableModules
2. In directory igt-tutorial/IGTLoadableModules, create a new directory OpenIGTLink-build
3. Cd to OpenIGTLink-build, and run the following command to configure the project:
ccmake ../OpenIGTLink
You need to set Slicer3_DIR as the build directory of Slicer3, i.e. Slicer3-buld. Also, make sure you have version 2.6 of CMake installed. If you don't, you can find in Slicer3-lib/CMake-build/bin. After configuration, run
make
To build OpenIGTLink. Upon completion, you should find libOpenIGTLink.so here at igt-tutorial/OpenIGTLink-build/lib/Slicer3/Modules. Copy it to igt-tutorial/Slicer3-3.0.2008-05-21-linux-x86/lib/Slicer3/Modules
