Difference between revisions of "IGT:ToolKit/Build-IGSTK"
From NAMIC Wiki
| Line 7: | Line 7: | ||
cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK co IGSTKSandbox | cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK co IGSTKSandbox | ||
| − | 2. In directory ''' | + | 2. In same directory, create two new directories '''IGSTK-build''' and '''IGSTKSandbox-build'''. |
3. Cd to '''OpenIGTLink-build''', and run the following command to configure the project: | 3. Cd to '''OpenIGTLink-build''', and run the following command to configure the project: | ||
Revision as of 15:59, 26 May 2008
Home < IGT:ToolKit < Build-IGSTKBack to IGT:ToolKit
1. In directory igt-tutorial, download IGSTK source code by running these commands:
cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK login answer by 'igstk' cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK co IGSTK cvs -d :pserver:anonymous@public.kitware.com:/cvsroot/IGSTK co IGSTKSandbox
2. In same directory, create two new directories IGSTK-build and IGSTKSandbox-build.
3. Cd to OpenIGTLink-build, and run the following command to configure the project:
ccmake ../OpenIGTLink
You need to set Slicer3_DIR as the build directory of Slicer3, i.e. Slicer3-buld. Also, make sure you have version 2.6 of CMake installed. If you don't, you can find in Slicer3-lib/CMake-build/bin. After configuration, run
make
To build OpenIGTLink. Upon completion, you should find libOpenIGTLink.so here at igt-tutorial/OpenIGTLink-build/lib/Slicer3/Modules.
