Difference between revisions of "4DUltrasound Preparation to use"
From NAMIC Wiki
| Line 1: | Line 1: | ||
| − | |||
= Preparation for the use of 4D Ultrasound = | = Preparation for the use of 4D Ultrasound = | ||
| Line 38: | Line 37: | ||
== Image Properties == | == Image Properties == | ||
| + | |||
| + | <flash>file=ApplyCalibrationData.swf|width=960|height=768|quality=best</flash> | ||
Revision as of 07:43, 20 August 2009
Home < 4DUltrasound Preparation to useContents
Preparation for the use of 4D Ultrasound
Update the Calibration file
The following section must be adjusted according to your setup:
Image Settings
- Image Margins
Tracked Ultrasound Calibration
- Offset tracker sensor - ultrasound transducer
You have to measure this offset manual. The axis are aligned like in the image shown below. - Tracker Sensor to Ultrasound Transducer Calibration
- Orientation of the sensor at calibration time
System settings
- Video Device Name
- Video Channel
Ultrasound Settings
- Ultrasound scan depth - This properties depends on the settings made at your ultrasound machine
- Ultrasound scan fan height
Manual Calibration
Prepare Slicer for Calibration
<flash>file=StartUpSlicer.swf|width=1024|height=768|quality=best</flash>
Get Calibration Data
<flash>file=GetCalibrationData.swf|width=960|height=768|quality=best</flash>
Apply Calibration Data
<flash>file=ApplyCalibrationData.swf|width=960|height=768|quality=best</flash>
Image Properties
<flash>file=ApplyCalibrationData.swf|width=960|height=768|quality=best</flash>
