Revision as of 22:20, 5 January 2012

Home < IGTView

Timeline

Task	Status	Deadline
Create module to replace OpenIGTLink Slice control		-
Add views		-
Add 3D camera control		-

This module is make to avoid copying OpenIGTLink source code in several module when needed to manipulate 2D or 3D views. By extracting slices control from OpenIGTLink, every module could use it without copying source code (not optimal).
2D views control has been implemented
Reslicing is implemented

3D camera control has been implemented, but a minor issue still remain:
- When we deselect the 3D camera control, the camera is not going back to original position, it only stays where it was at the end of the motion (identity matrix is not working because at the beginning camera is not at 0,0,0).

@@ Line 31: / Line 31: @@
 =Tips=
-* Orientation of EM and Optical system are different because coordinate system are different (not possible to "fix it"), so I created a model flipped, and use it to display EM tracker
-* Aurora configuration (from IGSTK):
-  communication->SetBaudRate(SerialCommunication::BaudRate9600);                   // Baud: 9600
-  communication->SetDataBits(SerialCommunication::DataBits8);                      // DataBits: 8
-  communication->SetParity(SerialCommunication::NoParity);                         // Parity: 0
-  communication->SetStopBits(SerialCommunication::StopBits1);                      // StopBits: 1
-  communication->SetHardwareHandshake(SerialCommunication::HandshakeOff);          // HandShake: 0