Difference between revisions of "IGT:ToolKit/Build-OpenIGTLink"
From NAMIC Wiki
| Line 5: | Line 5: | ||
2. In directory '''igt-tutorial/IGTLoadableModules''', create a new directory '''OpenIGTLink-build''' | 2. In directory '''igt-tutorial/IGTLoadableModules''', create a new directory '''OpenIGTLink-build''' | ||
| − | 3. Cd to '''OpenIGTLink-build''', and run | + | 3. Cd to '''OpenIGTLink-build''', and run the following command to configure the project: |
ccmake ../OpenIGTLink | ccmake ../OpenIGTLink | ||
| − | + | You need to set '''Slicer3_DIR''' as the build directory of Slicer3, i.e. Slicer3-buld. Also, make sure you have version 2.6 of CMake installed. If you don't, you can find in Slicer3-lib/CMake-build/bin. | |
Revision as of 17:39, 23 May 2008
Home < IGT:ToolKit < Build-OpenIGTLinkYou are assumed that Slicer 3 has been built on your computer.
1. In directory igt-tutorial, download OpenIGTLink module source code:
svn co http://www.na-mic.org/svn/NAMICSandBox/trunk/IGTLoadableModules
2. In directory igt-tutorial/IGTLoadableModules, create a new directory OpenIGTLink-build
3. Cd to OpenIGTLink-build, and run the following command to configure the project:
ccmake ../OpenIGTLink
You need to set Slicer3_DIR as the build directory of Slicer3, i.e. Slicer3-buld. Also, make sure you have version 2.6 of CMake installed. If you don't, you can find in Slicer3-lib/CMake-build/bin.
