Slicer3:Module Building
From NAMIC Wiki
Home < Slicer3:Module Building
In order to create a Slicer3 interactice GUI module that can be discovered at run-time, the following two files need to be created or modified.
ExampleModule.txt
Create this file alongside vtkExampleModuleGUI and vtkExampleModuleLogic. It's contents are key:value pairs describing the module. It's also used to configure build-time module selection. For loadable module support the following entries are used:
Name: Example GUIName: ExMod Dependency: Other Dependency: Another
Only the "Name:" entry is required.
CMakeLists.txt
In order to create the necessary source files to enable an module to be discovered at run-time, use the GENERATELM macro in the module's CMakeLists.txt file:
GENERATELM(ExampleModule_SRCS ExampleModule.txt)
This macro must be included after any TCL wrapping macros, as it adds to the source files for the library.