IGT:ToolKit/Build-OpenIGTLink

Back to IGT:ToolKit

Slicer3 is assumed to have been built on your computer.

1. In directory igt-tutorial, download OpenIGTLink module source code by running this command:

   svn co http://www.na-mic.org/svn/NAMICSandBox/trunk/IGTLoadableModules

2. In directory igt-tutorial/IGTLoadableModules, create a new directory OpenIGTLink-build

3. Cd to OpenIGTLink-build, and run the following command to configure the project:

  ccmake ../OpenIGTLink

You need to set Slicer3_DIR as the build directory of Slicer3, i.e. Slicer3-buld. Also, make sure you have version 2.6 of CMake installed. If you don't, you can find in Slicer3-lib/CMake-build/bin. After configuration, run

make 

To build OpenIGTLink. Upon completion, you should find libOpenIGTLink.so here at igt-tutorial/OpenIGTLink-build/lib/Slicer3/Modules.