Difference between revisions of "4DUltrasound Preparation to use"

From NAMIC Wiki
Jump to: navigation, search
Line 1: Line 1:
 
 
= Preparation for the use of 4D Ultrasound =
 
= Preparation for the use of 4D Ultrasound =
  
Line 38: Line 37:
  
 
== Image Properties ==
 
== Image Properties ==
 +
 +
<flash>file=ApplyCalibrationData.swf|width=960|height=768|quality=best</flash>

Revision as of 07:43, 20 August 2009

Home < 4DUltrasound Preparation to use

Preparation for the use of 4D Ultrasound

<= Back to project page

Update the Calibration file

The following section must be adjusted according to your setup:

Image Settings

  • Image Margins

Tracked Ultrasound Calibration

  • Offset tracker sensor - ultrasound transducer
    You have to measure this offset manual. The axis are aligned like in the image shown below.
  • Tracker Sensor to Ultrasound Transducer Calibration
  • Orientation of the sensor at calibration time

System settings

  • Video Device Name
  • Video Channel

Ultrasound Settings

  • Ultrasound scan depth - This properties depends on the settings made at your ultrasound machine
  • Ultrasound scan fan height

Photo-Tracker attached to Ultrasound.png

Manual Calibration

Prepare Slicer for Calibration

<flash>file=StartUpSlicer.swf|width=1024|height=768|quality=best</flash>

Get Calibration Data

<flash>file=GetCalibrationData.swf|width=960|height=768|quality=best</flash>

Apply Calibration Data

<flash>file=ApplyCalibrationData.swf|width=960|height=768|quality=best</flash>

Image Properties

<flash>file=ApplyCalibrationData.swf|width=960|height=768|quality=best</flash>