Difference between revisions of "Build Slicer3 on Dell Laptop Inspiron 1501 (Fedora Core 6)"
From NAMIC Wiki
Line 28: | Line 28: | ||
FIND_LIBRARY(OPENTRACKER_LIB | FIND_LIBRARY(OPENTRACKER_LIB | ||
NAMES opentrackerd opentracker | NAMES opentrackerd opentracker | ||
− | PATHS | + | PATHS /home/surg/projects/splot-build/opentracker/lib |
) | ) | ||
* Find this part | * Find this part | ||
FIND_PATH(OPENTRACKER_INC_DIR "OpenTracker/OpenTracker.h" | FIND_PATH(OPENTRACKER_INC_DIR "OpenTracker/OpenTracker.h" | ||
− | |||
"" | "" | ||
) | ) | ||
then change it to | then change it to | ||
FIND_PATH(OPENTRACKER_INC_DIR "OpenTracker/OpenTracker.h" | FIND_PATH(OPENTRACKER_INC_DIR "OpenTracker/OpenTracker.h" | ||
− | + | /home/surg/projects/splot-build/opentracker/include | |
) | ) | ||
Revision as of 20:46, 3 January 2007
Home < Build Slicer3 on Dell Laptop Inspiron 1501 (Fedora Core 6)If Fedora Core 6 has been installed on Dell Laptop Inspiron 1501, follow these steps to build Slicer3 on it:
Contents
Install tcl/tk
- Download free Tcl/Tk binary for linux from here:
http://downloads.akctivestate.com/ActiveTcl/Linux/8.4.14/ActiveTcl8.4.14.0.272572-linux-ix86.tar.gz
- Login as root and install Tcl/Tk
Get Slicer3 source code
svn co http://www.na-mic.org/svn/Slicer3/trunk Slicer3
Configure build if opentracker is required (e.g. for IGT Demo module)
In Slicer3/CMakeLists.txt, locate the OpenTracker section and perform the following changes:
- Change this line
OPTION(USE_OPENTRACKER "Need OpenTracker lib to build IGT Demo module." OFF)
to
OPTION(USE_OPENTRACKER "Need OpenTracker lib to build IGT Demo module." ON)
- Find this part
FIND_LIBRARY(OPENTRACKER_LIB NAMES opentrackerd opentracker PATHS "" )
then change it to
FIND_LIBRARY(OPENTRACKER_LIB NAMES opentrackerd opentracker PATHS /home/surg/projects/splot-build/opentracker/lib )
- Find this part
FIND_PATH(OPENTRACKER_INC_DIR "OpenTracker/OpenTracker.h" "" )
then change it to
FIND_PATH(OPENTRACKER_INC_DIR "OpenTracker/OpenTracker.h" /home/surg/projects/splot-build/opentracker/include )
Build Slicer3
./Slicer3/Scripts/getbuildtest.tcl
Run Slicer3
./Slicer3-build/bin/Slicer3